3 Education Tips from Someone With Experience

Timber Protection

Wood science is the study of wood as a material that is renewable and of biological origin. The processes and the tools used to utilize the material is what is known as wood technology. To be able to study wood it has to be compared to other products. The wood is checked against the other materials properties, performances, value, and work-ability. The many Merits of timber and these technologies improve wood to be superior over other products. The wide range of products where wood can be used is just one of the many advantages that give wood an upper hand over other products. It is also based on renewable resources. All the parts of wood can be put into use, and this makes it a better fit than other materials which most of their byproducts are a waste.

Protection of wooden structure and products is a must if you want to keep the good looks in place. The biggest threat to wood being moisture and insects has to be kept away from the wood. The moisture courses the timber to decay and the insects eat through the wood. There are many ways timber is treated among them being the ACQ in other words alkaline copper Quaternary. As the name implies the preservative is made of copper products. Although being a good method to use for wood protection it has presents some few challenges. It is a highly corrosive chemical that affects most metals that are used together with the wooden products. The concentration of the chemical that will be used to treat a piece of wood will depend on the where it is going to be used and the molecular structure of the wood. Timber being used around a water body will be dipped in a more saturated fluid than that being used above ground.

Another wood treating method that is fast being accepted is the use of copper metal. This method, unlike the ACQ, is friendly to the metal fasteners and its gaining popularity very fast. This process is what in other words called the micronized copper wood preservative. The copper metal is applied to the wood as small microscopic particles injected into the wood at high pressure. The process eliminates the need to dissolve the copper as is done in earlier copper-based preservatives. The characteristics of the wood are highly improved and the when this process is used to treat wood. The wood products protected using this method last longer.

The micronized copper preservative has proven to be highly effective in protecting the wood against fungal decay and termites. It has also shown to be an improvement in corrosion resistant properties to metal fasteners. When you use this method to treat wood, then you will not need to worry for at least ten years.